Thanks for checking out my ride! I am zonblitz on most forums, rx7club.com, tunerfriends.com, myspace, my330i.com, nopistons.com etc. The EgoInterceptor name comes from my gaming guild TEAMEGO.com Please go to our shop website, catfivemotorsports.com

My car is down atm, for turbo, fuel, ignition and suspension upgrades. Also doing some custom paintwork in the engine bay so have everything pulled out for the next few weeks. I'll have more/updated pics when it's done!

Recent repairs/upgrades:
Replaced gaskets for R1 Rear Spolier, Replaced all under hood fuse-box covers, replaced missing clips in rear trunk plastics, replaced overhead light lens in interior, replaced both resovoirs, cooling and washer/washer pump.

Disassembled doors to secure and shore up old rattle issues.

Roughly $9,000 in parts for new set of upgrades...
New Defi Oil and Fuel Pressure Gauges

Upgrades:
Suspension and handling: 5Zigen Pro Racer GN+'s 18x8.5's (Toyo T1-R 245/35/18) in front and 18x9.5's (275/35/18) in rear(12/28). Upgraded to Brembo Zinc coated Slotted and Drilled rotors (8/7) Stainless Steel Braided Brake Lines, Upgraded from Eibach Pro Kit Springs and Tokico Illumina 5-way adjustable Shocks/Struts. (1-30) to JIC Magic FLT-A2 15-way adjustable coilovers! Added racing beat front and rear sway bars, sway bar brace, Added Cusco front strut brace (11-5-06)

Engine & Performance: Stage 2 Rotor Sports Racing 13B engine with Street porting and stainless braided oil and clutch lines, ACT Racing Clutch, Fluidyne Hi-Flo Radiator with Silicone hoses, Aluminum AST, Polished aluminum intake and intercooler hoses, Apexi Power Intake (dual cone), Racing Beat dual tip with 3" stainless exhaust. Replaced stock pre cat with Bonez 3" DP (8/7), factory cat with Hi-Flo cat (8/7), wrap DP (8/7), Install Efini Y-pipe (8/7), Greddy SMIC (8/7), with HKS BOV (8/7), Greddy Elbow (8/7), Turbohoses.com silicone couplers (8/7), Installed Apexi Power FC (8/7), Removed air pump and replaced with idler and replacement pulley and belt (Greddy)(8/7). Installed Optima Blue Top (to match) (10/1) and RX7 store rotary polished aluminum oil cap and Greddy Radiator cap.(10/25) Installed Greddy Profec B Boost controller...(11/10/05)BNR Stage 3 Turbos with ported 38mm wastegate, Full Non-sequential conversion courtesy of Freddie Hebert, Fuel System upgrade to Supra pump, lines, 1300cc secondary injectors, and ported rails, HKS Twinpower Ignition, M2 Intake to replace current Apexi dual cone, Ported Intake manifold, exhaust manifold and TB, removed dual throttle in TB (In process)



Repairs since took ownership: Replaced both Radiator fans, repaired power antenna, replaced passenger side exterior door handle, replaced 2 a/c lines and converted to R134a, Replaced all upper and lower control arm bushings in the rear, repaired rear divider (spring), rewrapped leather steering wheel, replaced stock Intercooler (hole, replaced battery tray), Replaced A/C evaporator (8/3), replaced both thrust braces (8/3), replaced front defrost grill (8/3), replaced brake pads (8/3), replaced rear hatch cover (8/3), replaced wires and socket for drivers side marker (front) light (8/3), Replaced Radiator spacers (8/7), Diagnosed boost issue with secondary turbo, was missing boost pill, replaced (8/7), replaced inner and outer tie rod ends (8/7), replaced broken forward crossmember below IC and Battery (8/7). Replaced clutch master and slave cylinders (8/12). Replaced all exterior rubber seals including windshields. (10/25) Replaced engine cowl (10/25) Replaced R1 lip spoiler (10/25) Replaced spilt hose to wastegate actuator (12/15) Replaced cigarette lighter assembly 1/20/06. Replaced side mirror interior triangle, Replaced drivers door cubby hole lid. 1/24/06. Replaced Rear wheel bearings (7/14) Replaced all manifold gaskets

In the works (Parts in my garage awaiting installation): Upgraded Denso-Nippon Fuel pump, 1300cc secondaries, lines...RE Scoot CF Hood, HKS Twin Power Ignition and Water/methanaol injection kit, new engine wiring harness, Innovate Wideband, Defi Fuel Pressure and Oil Pressure Guages, magnacor 8.5mm wires, Greddy alt, h20 pump and power steering pulleys. FlyRX7's triple center speaker guage mount, pettit steering column mount, Stainless steel braided brake lines from pettit, Polished UIM, TB, Secondary turbo inlet pipe, alternator case.

Repairs In the works: Replace engine wiring harness, Fuse box covers, Replace my welded fluidyne radiator with mazdaspeed radiator.

Upgrades in the works: Interior: BNR Stage 3 Turbos, and Non-sequential conversion... Stage 3's arrived today will post pics tomorrow! JIC Magic FLT-A2 Coilovers, New 6000k McCulloch HID Ballasts/Bulbs, Racing Beat Front and Rear Sway Bars, JDM Efini steering wheel

Exterior: Had car repainted by H.T. Customs, Porsche Seal Grey Metallic(10/25) Replaced all 4 sidemarker lights with new clear versions, replaced back up lights with new clears, replaced worn factory bumper lights with new RX7store.com smoked clears. Replaced missing badges with Japanese Efini badge kit. Installed 99 spec efini Tailights (12/26) Had windows tinted with 20% all around for a nice even finish. (1/31) Painted clear corner lights with smoke paint for a stealth look (2/8). Installed Evo-R Sleek Headlight kit. (2/13) Having UIM, TB, secondary turbo intake pipe, alternator and Y-pipe polished for a nice finish! Upgraded to mcCulloch HID kit (ballasts bulbs) into current headlight projectors... WOW!

Interior: Defi Boost and H20 temp gauges with A-pillar mount, upgraded worn shifter and ebrake with new MOMO replacements. Installed RX7 store armrest, polished a/c knobs. Removed interior and lined floors, doors and hatch area with Dynamat Extreme.(11-4) Replaced Yellow/Black seats with new Katskinz Grey on Black, pics below. (12/20) Installed Gotham Racing Power FC Holder (1/27). Replaced worn shift and e-brake boots with new italian leather from redline (2/8).